Is anyone using the primer stop switch on a Dillon 650 or like press?

Starvingboy

Well-known member
Feedback: 2 / 0 / 0
Joined
Mar 19, 2017
Messages
489
Location
Central Ohio
I've done the manual version: Unscrew the little plastic primer cam, when I'm doing a load of prep-only brass. Looks neat, just not sure it's $30 worth of neat.
 

arch stanton

Moderator, FFL/SOT, UZI Talk Life Member,
Staff member
Feedback: 81 / 1 / 0
Joined
Jan 18, 2003
Messages
3,022
Location
Wisconsin-Indonesia-Thailand Live @ The Blue Note
Yes...I also like the case feed stop... i have most of the enhancements from Uniquetek. https://www.uniquetek.com/dillon-press-enhancements

Yes I do as well this would be the last thing I can do with my two presses short of the quick disconnect for the powder charge
I just installed the bearing upgrade for the indexing cam that is very nice and the metal turret ejector bolt cover as well very nice
 

slimshady

Well-known member
Feedback: 0 / 0 / 0
Joined
Sep 19, 2004
Messages
967
There is a 3D printed version if you just wanna try it out for about a buck's worth of filament. I have one on mine, the Ebay one, and it works fine when I remember to re-enable it!
 
Status
This thread has been closed due to inactivity. You can create a new thread to discuss this topic.

Please Visit our Sister Sites Below

Sister Board - Sturmgewehr Sister Board - MachinegunBoards


Please consider becoming an UZI Talk Supporter
Top