Search results

This is great news. Is the list the email you have use early on, or is there a different list on Sam's website? I believe I emailed the original address back when you gave it out.

It's been a while since the last update. Any good word, or any word at all?

The chamber looks good, and I haven't had an issue with any other brands. I think it's the ammo.

Has anyone tried Turan 9mm ammo? I tried running it through my M-11/9 with Lage Max-11/9 upper. It wasn't a good combination. By the third round the cases were severely deforming and had case head separation. I haven't tried it in anything else.

Two drums arrived today. One is in very good condition. The other is in good useable condition, with finish wear, but no dents. Well worth the price. I ordered one of the coffin mags from Atlantic too. I hope it turns out to be as nice.

Looks like they have the bolt on the site. https://parts-dispensed.com/home/246-m11-bolt-and-charging-handle

Can this be used to fire .380 through a M11 .380 gun? Sorry if this is a dumb question. Next dumb question. Can this be used in Lage uppers?

I would recommend looking at OSS (now HUXWRX) rifle cans. Lower back pressure than a traditional baffle style can, and minimal rate ROF increase.

I have no info about the spring. Glad Concorde could help. You have been waiting 800 days for your stamp? The stamp came through on my M11 about a month ago after over a year of waiting. I thought that was bad, but it wasn't 800 days bad. I feel for you.

Email sent. It may be a wait, but at least it is moving forward. Any guess on pricing? I'll start saving my pennies. Thanks for putting in the work on this.

I probably said this towards the beginning of the thread, but I am in for both a M11/9 and baby M11 . I know the ATF will be the rate limiting step in this process, but I will get in line as soon as it forms. Thanks for putting the work in on this. I'll be buying ammo and saving my pennies...

Thank you for the update. That is such good news. Your 3d printed mag, is it the same as a currently existing commercial mag?

I failed to describe the issue I am having. Using the FTF mags with the Lage upper every round noses into the bottom leading edge of the chamber. The original mag works fine, and the FTF mags work fine in the original upper. It's as if the mag doesn't seat high enough for the Lage upper, or...

I recently bought some of the 380 mags from FTF. They seem to run fine when I use the original upper, but all failures to feed with the Lage M11A1 Mark II upper. The original mag works fine with the Lage upper. Any suggestions to make the FTF mags work with the Lage upper?

I was able to remove the grip. It was just threaded on. I just needed to try a little harder. Thank you everyone for all the information.

Mine is on Lage M11 MkII upper. I want to remove it, and add a grip to the bottom uppers bottom rail. Putting it on an original style upper seems more useful.

Good tip. I think you can boil it for a few minutes too. In this case freezing would probably be better.

I'll give it another try. It must be easier than I am making it.

I was told the barrel has 3-lug. The part below the plastic grip is lesser against the wrench flats on the barrel. It doesn't compress and turn like a 3-lug mount.

I recently purchased a M11/9. It has a grip attached to the barrel. On the 3-lug I believe. I was able to remove the top plate and pin, but not the rest. I tried to remove the plastic grip, but was not able. Maybe I didn't try hard enough. Any advice.