Search results

I bought 3 and none came with a sling. Kevin

I live in Gainesville so I took my Uzi down to Richard a number of years ago for some work then went and picked it up when it was ready. We talked for over an hour each time. He was so knowledgeable and showed me a lot of stuff he had in his shop. His skill and knowledge will be missed. Kevin

Strobro32, Mine does not have that tab.

Strobro32: I don't know exactly what you are referring to. If you have a picture I will pull mine out of the safe and get back with you. Gaujo: 9MM Auto is 380 ACP

I looked for years before I found one. Mine is marked as follows; INGRAM M11, CAL 9MM AUTO MILITARY ARMAMENT CORP POWDER SPRINGS, GA, USA

Sending it in just like the current form. Will update this in @ 12 months or so.

Thank you all for the information. Kevin

Thanks to everyone who replied. I understand the fact that common practice was to send in the new form exactly like the old one and have done it that way for years. My fear is that what is on my form will be wrong when compared to the original registration in their file. Has anyone had a SWD...

I am about to transfer a SWD M11/9 and with BATFE being so picky lately I want to make sure the Form 4 information I have is correct. Is the following the correct information? ON THE CURRENT FORM: Manufacturer: Daniel, S.W., Inc. (SWD) 1872 Marietta Blvd. Atlanta, GA 30318 Model: M11/9...

I just found a couple of 40 round mags that I received when I purchased my PS M10/9 back in 2005. I would like to know who made them. They are grey parkerized and have "M10-9MM" stamped on the body. Any guess on who made them? Thanks, Kevin

Concord, That is correct. It was like that when I received it and I am going to rebuild it. Also thanks to Root and Shattered for the information. Kevin

I just received an original MAC M11 380 suppressor in which someone decided to remove the eyelets from the first stage. I would like to replace them and need to know what size and how many? Thanks, Kevin

Jack007, Thank you for the information. The bolt in my PS/RPB Overstamp M11 has a L in a circle. What does that signify? Thank you, Kevin

I am trying to find out if the bolt RPB used in the M11 (380) is exactly the same as the bolt used by MAC in the Powder Springs M11.

Picture of magazine showing where bolt hits the follower. I do not know how to make the picture appear in the post. The link is a pdf. Kevin

Timkel, Mag fits fine and the lock up is good. They are the newly manufactured mags from RPB and are built well. I do not know if the bullet height or angle is correct. If you could post a picture of a correctly positioned round in a mag I will compare it to mine. I do not have my camera with...

I just received one of the new RPB M11 mags to use in a FA PS/RPB overstamp M11. I inserted the mag in the gun to function test it and the bolt hits the upper left corner of the follower, not the feed lip but the follower, and will not continue forward. It hits the follower @ 3/32 below the...

That sounds like the kits Cole's sold @ 10 years or so ago that ATF determined to be improperly demilled. I purchased two of them which earned me a visit from my friendly AFT agent. I turned in the receiver pieces and kept all of the other parts.

Where can I purchase the new metal M11 mags that came out last year? I am looking for the newly made mags made on the "original tooling" that work in the Powder Springs M11 (380). Thanks, Kevin

Never thought I would need a 3/32 pin punch until I did the same thing. Kevin