Search results

I was figuring it was personal at this point!

I found a 4oz weight difference between the original 1973 cast bolt in my M10 and the new CNC one I purchased. ROF difference for my standard 124gr ammo was also noticeable: the CNC bolt in an M10/9 is the slowest near factory configuration, around 1000 rpm. I’ve since sold my M10/9 or I would...

https://macmachineguns.com/?product=eliminator-selector-lever-delete-m119 I use one of these in my M11 in conjunction with the Lage competition trigger. Works exactly as advertised.

Honestly hunting down an old EOTech Mk56 would be dynamite

Had my M10/15 out on Sunday, ran a coupled pmag (58 rounds) without issue, shooting some of my light loaded 55gr ammo. ROF was a direct comp to the M249 we were also shooting with a 14” barrel (non adjustable gas-fire rate). The M10/15 was a lot easier off the shoulder!

Individual to licensee is still a form 4 and $200. I have a 2 stamp can that was “free” as long as I paid both stamps. Two stamp transfers hurt less in the AOW world!

I had one I had to completely butcher to remove. Installed with copious rocksett or similar, and torqued to the point the threads and shoulder were deformed. That barrel become a throw away. I used all the tools of persuasion first I promise!

For those waiting, here’s a brief clip from this morning. My phones mic cut out the actual gunshots so mostly you hear the carrier cycling. https://m.youtube.com/watch?v=jaEa41LPTDw&feature=youtu.be

I find the current production CNC bolts to run about 125-150 rpm slower than the original cast bolts in 9mm — which makes sense, since they are often 4-5oz heavier.

Touché

First impressions: what a genius piece of engineering. I revel in gently putting the latch in place with a mag through the grip magwell. Flawless operation for the first 300 rounds. Overgassed quite a bit initially. I need the adjustable block restricted 1 from closed for full power m193, and 4...

Pretty sure this is how Gordon Ingram imagined it would someday appear.

Number 33 was ordered today. I have some pre-pandemic m193 that was purchased for this moment over three years ago.

Hello, it’s someone who wants to tinker :-)

#286, crickets! I kid. Not about the 286 — just the expectations. I ordered an AR18 repro stock with a 1913 attachment and I have a clarion vision of how my M11A1 will look on the other side.

Just ordered the 1913 Brownells AR 18 repro stock, for the PS 1913 stock adapter, with a plan for a 14.5” barrel. Unfortunately, still 300 deep on the 11A1/15 waiting list.

Yes, I was all IRM, but now ARRM looks pretty tempting. The 16” didn’t look ridiculous on the M11A1, so that has also rekindled my excitement.

I purchased a pen gun from John as he sold his remaining inventory after moving out of the NFA business. The form 4 (two stamp transfer) was approved after 13 months and just arrived in the mail to him now. Not sure where else I could post this (I bought it off this forum!), but wanted to share...

Okay. One of you fellers just floated past my upper bound on a Fleming kit for a Mac 10/22. This one can’t get released soon enough!

30 on one list 230 on the other, correct answer is buy both, but I think I may just wait for the little one if the list will be through by the end of the year. I’ve been waiting 3 years, what’s 10 months?