Search results

Hi Mike85220 could you tell me where you have seen or have experienced "Sears can wear" and at which location on the sear does this happen thanks. Regards, PeterNNH

CV - IMO - I think they have but it has been reincarnated in a more compliant easier to export form to comply with German export laws and US import nuances (topics I know nothing about). I have compared the two side by each and the differences are minor. BTW I looked up Alder Brook it looks...

forgot to add I think its allowed for importation because its a pistol I am sure there was a lot of ATF scrutiny also I read that the German govt classified it as a sporting firearm not paramilitary

Other than the receiver pin below the rear sight which precludes the use of an mp5k bolt carrier (unless carrier is modified by machining the top to flatted the carrier) and a different shelf on the receiver and thus trigger housing mating surface - its the same. Both parts mentioned above are...

My experience after living with many non HK based clones - HK is expensive (so are beemers audis and benz did u notice) and high quality (good metal, machining and QC), IMO well worth it, my sp89 and other German based clones (most roller locked are) shoot and shoot and shoot. Ive had vectors...

Try allhkparts http://allhkparts.com/