Search results

I have stacked buffers up think I went 3-4 it will speed it up a little bit.

The extractor normally breaks the tip of the hook off.

The ones I had made were out of viton. They have been holding up for several k so far.

Probably parked the inside

The more I run mine it is getting better, though I can tell it doesn't quite feed smooth from the rof stumbling at times.

Yes they break and there are 2 different ones a long and a short. If you need one to copy I could send one from a 760.

Yep needs bevel to get feed right

1k some parts can be used on it or off of it lol

Thanks for the heads up. Have a few but one more can't hurt lol

Yep found a box full when cleaning the garage

If it's FA I have one.

Think it's around 1k+ Tried Wolf Tula Some other steel I had, 62gr military and 55gr military. So far pmc bronze is the only one that I can run a 100 rnd belt with no stoppages.

So far the only ammo I found to work consistent is pmc bronze on my bpp 23e. Otherwise it will not advance the belt every 5-10 rounds with various ammo. Been working on some reloads to see what I can do with that. Unfortunately there is a fire ban here so no shooting/testing reloads for now.

try soumi mags mine runs most of them no mods.

They have a removable firing pin held in with a roll pin I can look at mine tonight if you need pictures let me know.

only load 19 in the mag mine almost always chunks the first round

I would guess the SD

LMAO I nthought it was all sliding these days.

I load 147gr with long shot if i want lower power I just load 135gr bullets they still run in the sub guns just slow them down a bit.

Didn't someone make a .22tcm one. Well tried and ran into multiple issues as I recall. It would have a cool factor for being loud and no recoil.